Contact Lens Care
About Contact Lenses
Lenses & Lifestyle
Prescriptions & Eye Tests
How to Tighten my GlassesMedically reviewed by Khuram Sarwar, Dispensing Optician at Feel Good Contacts.
- Issues glasses wearers have with loose-fitting frame
- How can I keep my glasses from sliding down my nose?
- How to adjust your glasses at home
- How do you tighten screws on glasses?
- Make minor adjustments
- Protect your glasses from the start
- When to take your glasses to a professional
- Glasses for up to 70% off at Feel Good Contacts
If you wear glasses and have worn them for a while, you may have experienced that they begin to slip off your face over time. Loose glasses can be annoying to keep pushing back up again. They can also end up looking crooked and not sit well on your face, affecting your line of sight.
Issues glasses wearers have with a loose-fitting frame
Here are some of the most common issues that can occur from an ill-fitted pair of glasses:
- The nose pads move out of place
- The screws on the glasses become too loose
- The temple arms of your glasses move out of place
Properly fitted glasses will ensure that you always have clear vision, therefore a properly fitting frame is essential.
How can I keep my glasses from sliding down my nose?
The following tips can help your glasses fit perfectly:
- Tighten your glasses at home – this will prevent them from sliding down your nose.
- Clean your face and glasses to remove any dirt or sweat. This can stop them from sliding down your face.
- Keep a cleaning kit handy. Use our Feel Good Cleaning Kit; it contains all cleaning essentials for your glasses, and it fits perfectly in your bag.
We highly advise that you visit an optician and ask them to adjust your prescription glasses for you. If you go to your regular optician, they will usually do this for free, or for a very small fee. If for any reason you cannot reach your optician, here is our short guide on how to adjust your glasses yourself.
How to adjust your glasses at home
In just a few simple steps, you can adjust your pair of crooked glasses to stay functional, as well as ensuring they feel the most comfortable.
Deciding on what adjustments to make
Before you adjust your wonky glasses, you need to determine what the problem is. Here are some of the various problems you may encounter:
1. The glasses are loose or sitting crooked
If you have crooked glasses or your glasses are loose, you’ll need to bend the left arm and/or the right arm. Here’s how to adjust the arms:
- If the glasses are loose - simply heat up the plastic temple part of the frame and gently bend the arms towards each other around the area of the temple tips.
- You can heat up the frame by using a hair dryer. Simply apply the heat for 20-30 seconds.
The temple arms may become crooked and bent over time, often tilting to one side. This is how you can fix this problem:
- Lay your eyeglasses upside down on a flat surface.
- Both of the temple arms should rest evenly without looking bent. If they do not, you will need to adjust them
If the temple arms are crooked, make note of whichever side sits higher and bend the opposite temple arm down at the hinge or where it bends behind your ear.
If the left lens is higher than the right lens, bend the right temple arm down.
If the right lens is higher than the left lens, bend the left temple arm down.
Top tip: We only recommend doing this with wire metal frames. Plastic frames with thick temple arms may need to be heated to adjust; we do not recommend trying this at home. You should seek the assistance of your optician.
2. Your glasses are too tight or are sliding down your face
If your glasses are too tight or are sliding down your face, you may:
- Need to run the temple tips under warm water for 30-60 seconds before bending them into place.
- You can also use a hairdryer for 20-30 seconds.
If your glasses are too tight - carefully bend the temple tips upwards to relax the curve.
If your glasses are too loose - bend the temple tips downwards to add curve.
Try them on again and check if the fit is better. If not, repeat the same process until you are satisfied with the fit of your glasses.
Top tip: Whatever you do, avoid putting your lenses under hot water as this can damage them..
3. One lens is closer to the eye than the other
Please follow the diagram instruction to fix this issue:
If your left lens is closer to your eye than your right lens, either bend the left temple arm in or the right temple arm out.
If your right lens is closer to your eye than your left lens, either bend the right temple arm in or the left temple arm out.
4. Your glasses are pinching your nose or are sitting too high/low
Nose pads or nose pieces are a common feature on glasses, they are designed for added comfort. As nose pads are adjustable, over time, they can move out of place. If your nose pads are out of place, simply tilt them back into a position that sits most comfortably on your nose, they should slip back into position when you move them.
If your glasses are pinching the nose - push the nose pads away from your nose until they feel comfortable.
If your glasses are sitting too low - push the nose pads closer together using your thumb, until they fit comfortably on the sides of your nose.